This is guidance to tell you how to replace the cracked or broken Samsung galaxy s5 screen assembly replacement. If your Samsung galaxy s5 is unworking or non-functional, or screen cracked, this guidance can guide you to fix it easily.
Compared to other Samsung phones, such as Samsung galaxy s4, Samsung galaxy s5 have a new way to open the case and replace the broken screen. It is not that hard to make it. Now let’s together have a see at these replacement details, total in 10 steps.
First, prepare for cell phone repair tools this replacement need.
Plastic pry opening tool
A tip of a Spudger
Plastic pry sticker opening tool
Step 1. First and importantly, make sure your Samsung galaxy s5 is power-off.
Step 2. Take off the back cover and remove the battery.
Step 3. Remove the MicroSD and SIM Card.
Step 4. Use a plastic pry opening tool to pry up the plastic midframe connector panel.Remove the connector panel with a pair of tweezers.
Step 5. Use the sharp tip of a spudger to pry the home button cable connector straight up off its socket.
Following is to remove the display assembly, we know there is adhesive between the display assembly and rear panel. So we should be careful to deal with these parts.
We’d better use the heating tool to heat the display properly first, such as iOpener heating.
Step 6. Place a heated tool on the left side of the phone for at least 90 seconds.
Note: You can use the Microwave Oven to heat the heating tool to about 90℃. And you can also use the heat gun or temperature sensor.
Step 7.Use the Plastic opening pry pick to separate the adhesive securing the front panel glass. Only pry where directed. If you experience resistance, stop sliding the opening pick and reapply heat.
There are 4 parts the plastic opening pry pick sliding you shoule notice.
I. When it reach the corner, stopping before the speaker grille at the top of the phone. So slide the opening pick across the top of the phone, You should be very careful not to insert the pick too deeply.
Because the adhesive securing the top of the phone is only a narrow strip above the earpiece speaker. Slide the pick along the top of the speaker to avoid damaging internal components.
II. Carefully slide the pick around the upper left corner, if you encounter any resistance from cooling adhesive, reapply a heated iOpener to the left side of the phone.
III. Slide the very end of the opening pick across the bottom edge of the display to separate the last of the remaining adhesive.
Because the bottom end of the phone contains the soft button and home button ribbon cables. If you insert the opening pick too far into the phone you risk cutting these cables.
IV. Finally, if the front panel is not easily freed, the adhesive on the soft button cable may need to be separated.
These cables are thin and easily damaged, therefore be certain you are only peeling them off the screen display assembly and not lacerating them.
Insert an opening pick under the soft button icons on the screen display and pry the button flex cables down off the inside of the front panel.
Step 8. Slightly lift, but do not remove, the home button end of display assembly.
This place you must take more care for it. Do not remove the front panel entirely. It is still attached by a connector.
Step 9. Use the sharp tip of a spudger to lift the front panel assembly cable connector straight up off its socket on the motherboard.
Step 10.Safely remove the front panel assembly from phone, you’ve get the Samsung galaxy s5 lcd screen display assembly.
Then you can use the new replacement screen lcd digitizer assembly for Samsung galaxy s5 to install on your phone,
By the way, I have to notice you again, please read the guidance carefully, especially those notices.
Be friendly with these cell phone replacement parts. and have a nice replacement “trip” for your Samsung galaxy s5!